The small sample holder makes light work of tests where samples of irregular or hard to grip shapes are being measured.

Three sets of top and bottom plates are supplied with 5mm, 10mm and 15mm apertures to maximise test flexibility. These plates are positioned above and below the sample in order to firmly hold it in place ready for testing. Plates can be easily interchanged using a unique hinge mechanism allowing quick set-up of test measurements.

Compression springs provide support to the top plate and enable users to finely adjust its position to prevent pre-test damage to samples.

The fixture is an ideal solution when performing texture measurements, such as puncture tests on samples that are normally difficult to grip and keep in place.

Contents and Summary

TMS Small Sample holder base with set screws
Three bottom plates, one solid, two with holes for product
Three hinged top plates
Four thumb screws and springs for securing the plates

Must be used in conjunction with:
-TMS standard fixture table (432-243)
 

Applications

• Puncture and penetration tests of small foods such as small berries and jelly sweets
• Puncture and penetration tests of larger food products such as whole eggs, fruits such as plums, and confectionery bars